Maintenance Of The Extractor Hood - Venduro TA-600 Manual

All manuals and user guides at all-guides.com
ENG

Maintenance of the extractor hood

Do NOT carry out maintenance while the device is connected to the mains or in operation!
It is recommended to clean the grease filters every other week! This can be done using the dish-
washer or by putting the filters in a solution of boiling water and a detergent or soda pellets. Let the
vervangen vet/koolstoffilter
filters dry thoroughly and place them back in the cooker hood. This prevents the filters from catching
fire and ensures the continued optimum operation of your cooker hood.
The best way to clean the inside of the cooker hood is with a soft detergent. Do NOT use abrasive or
acidic products.
Maintenance of the extractor hood
When removing the grease filters, it is recommended to protect the cooker using a piece of Sty-
rofoam or polystyrene. This way you avoid damaging the cooker in case the filters drop from your
hands. Pay attention if the cooker is no longer operating!
You can remove the grease filter by:
• Pushing the stainless steel cap away from you into the U-section (1).
• Lowering the front side of the filter (2).
Extra tip
You can keep the cooker hood system clean by boiling a pot with water, lemon juice (from one lemon)
and a glass of vinegar for 20 minutes. Have it boil with the cooker hood set at position 2 and then let
the cooker hood run for another 15 minutes.
In case of a plasma system, apply the same method and rinse the hydrosorb filter in water with
detergent. The grease filters can be cleaned in the dishwasher every 2 weeks.
42