Washable Carbon Filter; Touch Control - Venduro TA-940 Manual

ENG

Washable carbon filter

Cleaning instructions
Remove the washable carbon filter from the hood.
Wash the filter in a dishwasher at the maximum temperature using a common household detergent.
MAX temperature 70°C.
It is recommended to wash the filter alone without dishes to avoid traces of food that can be
deposited on the filter, causing bad smells. After the washing, let the filter dry perfectly inside the
dishwasher or in-room.
Reactivate the carbon filter putting it in the oven at a maximum temperature of 90°C for about
60 min.
Reassemble the filter on the hood. In order to guarantee a better performance of the carbon filter
making a normal use of the hood, it is recommended to wash and regenerate the filters at least once
every two months.
Remove the washable carbon filter from the hood.
Filter specifications
LIFETIME:
The filter lifetime is influenced by many factors like:
• the types of pollutants exposed to the filter and their concentration;
• period of exposure;
• speed/flow rate performance of the hood.
These may affect the filter behaviour even after its regeneration in a significant way.
For a normal use of the hood at a medium operating speed, the carbon filter tends to reduce its smell
absorption capacity after progressive regeneration cycles. Approximately, it is recommended to
replace the filter after 2 years of use.
DISPOSAL:
As regards the disposal, the provision requires all used carbons to be firstly analised and
then disposed according to the result of the tests. In the specific case of the domestic field,
the absorbed compounds are not harmful to the environment, thus they can be disposed
as general, in compliance with local and national regulations. The user shall deliver the
product to specific local collection centres.
46

Touch control.

When the motor is active, the LEDs on the touch control constantly present the current status
(speed and filter).
2 Buttons
• Light on/off: can be held down longer in order to dim
• Motor on/off: can be held down for a shorter or longer time
5 LEDs
• 3 speeds + boost function
• Filter indication
When the motor is started by pressing on the
Another press on the button increases the speed by 1 level.
Once the motor is already at boost level, pressing the
So the successive levels are 0-1-2-3-boost-0-1-2-3-boost, etc.
The boost speed can only be active for a certain period, after which the exhaust will drop back to level 1.
The shut-off delay time can be activated by pressing on the
the motor is active.
The lighting is switched on/off by a short press on the
will cause the lighting to begin to dim. When the lighting is at the minimum level, the lighting will
begin to return towards the maximum. If the user thus continues to dim, the lighting will dim
continuously between the minimum and maximum strength.
After the motor has worked for a certain period, the filter must be cleaned. Once this filter period
has passed, the filter LED on the touch interface or the remote control will light up. The filter time-out
can only be reset if the filter time has actually passed.
Via the touch control the filter time-out can be reset by holding down both buttons
for an extended time.
button, it begins at level 1.
button again will turn the motor off.
button for an extended time while
button. Continuing to press on the button
(and)
ENG
47