Network Bullet Camera·Quick Start Guide
Please insert the expansion screws first if the camera is mounted
to the cement ceiling. And you can use the self-tapping screws
directly if camera is mounted to the wooden ceiling.
3. Adjust the surveillance angle.
1). Loosen No.1 lock screw to adjust the tilt angle [0 °~100°].
2). Loosen No.2 lock screw to adjust the pan angle [0°~360°].
3). Loosen No.3 lock screw to rotate the camera [0°~360°].
4). Tighten the lock screws.
A wrench is supplied to loosen and tighten the screws.
Figure 2-2
Install the Camera
14