Advertisement
CMBS Indicator
U.S. model is shown.
This indicator comes on for several
seconds when you select the ON
mode by operating the engine start/
stop button (see page 194). It also
comes on and stays on when you turn
the CMBS off by pressing the CMBS
OFF button.
To switch the CMBS back on, make
sure the vehicle is stopped and the
power mode is set to ON, then press
the CMBS OFF button for about 1
second.
The CMBS indicator normally comes
on under these conditions:
When you manually switch off the
●
system.
When the system shuts off
●
automatically.
When you drive in bad weather
●
(rain, snow, fog, etc.).
If anything covers the radar sensor
●
cover (dirt, mud, dry leaves, wet
CMBS
INDICATOR
snow, etc.).
When the VSA system indicator
●
comes on (see page 508).
Collision Mitigation Braking System™ (CMBS™)
2011 ZDX
When you select the ON mode by
●
operating the engine start/stop
button, the CMBS indicator should
come on for a few seconds, then go
off. If the indicator comes on at any
other time and a CHECK CMBS
SYSTEM message appears on the
multi-information display, there is a
problem with the CMBS. You can
still drive your vehicle, but CMBS
will not be operating. Have your
vehicle checked by a dealer.
CONTINUED
503
Advertisement
