Advertisement
Replacing the Remote Battery
Replace the battery if necessary.
Battery type: CR2032
To replace the battery:
1. Remove the built-in key (see page
207).
2. Remove the upper half by carefully
prying on the edge with a coin.
3. Replace the old battery with new
battery. Place the battery so the ＋
side is facing up. Snap the two
halves of the remote case back
together.
An improperly disposed of battery
can hurt the environment. Always
confirm local regulations for battery
disposal.
2011 ZDX
Keyless Access System
As required by the FCC:
This device complies with Part 15 of
the FCC rules. Operation is subject
to the following two conditions: (1)
This device may not cause harmful
interference, and (2) this device must
accept any interference received,
including interference that may
cause undesired operation.
Changes or modifications not
expressly approved by the party
responsible for compliance could
void the user's authority to operate
the equipment.
This device complies with Industry
Canada Standard RSS-210.
Operation is subject to the following
two conditions: (1) this device may
not cause interference, and (2) this
device must accept any interference
that may cause undesired operation
of the device.
CONTINUED
191
Advertisement
