Advertisement
Radar Sensor
RADAR SENSOR COVER
The radar sensor cover is located
under the Acura emblem in the front
grille. If the radar sensor cover is
covered with mud, dirt, dead leaves,
wet snow, etc., or if you put a sticker
on it, the CMBS will automatically
shut off, and the CMBS indicator on
the instrument panel will come on.
You will also see a ''CHECK CMBS
RADAR SENSOR'' message on the
multi-information display for about
5 seconds.
Collision Mitigation Braking System™ (CMBS™)
BOLTS
(Do not tamper)
Always keep the radar sensor cover
clean. If it gets dirty, clean it with
water or a mild detergent. Never use
chemical solvents or polishing
powder.
There are three bolts on the sides of
the radar sensor. Do not tamper with
these bolts, or you may cause the
system to malfunction.
2011 ZDX
Do not allow anything to impact the
radar sensor or the radar sensor
cover.
If either of these parts receives a
strong impact, switch the system off
by pressing the CMBS off button,
and have your vehicle checked by a
dealer. If the front grille ever needs
to be repaired, consult a dealer first.
If the radar sensor cover or the radar
sensor ever needs to be removed,
take your vehicle to a dealer.
When the CMBS is on, the radar sensor
constantly scans for vehicles directly
ahead of you. This means that driving
on a road with a few or no vehicles
could cause a CHECK CMBS RADAR
SENSOR message to appear on the
multi-information display. This is
normal and not a cause for concern.
CONTINUED
499
Advertisement
