Operation - HOMCOM 850-223V90 Manual

EN

Operation

Check before switching on!
DANGER! Risk of injury! The device
must only be put into operation if no faults
are found during the check-up. If any part of
the device is defective, it must be replaced
before the next use.
Check the safe condition of the device:
– Check whether there are any visible defects.
– Check whether all parts of the device are firmly
attached.
– Check whether the switch is on [0] before you
insert the plug into the outlet.
Electrical connection
– Connect mains cable to outlet.
DANGER! Risk of injury! The device may
not be mounted directly below a wall outlet.
Danger of cable fires!
LED Panel diagram
► P. 11, item 1
[ ]: On/Off
[ ]: Mode icon
[+]: Temperature and time setting
[–]: Temperature and time setting
– Choose mode, press [ ] button to select the
modes in this sequence: Comfort mode – Eco
mode – Defrost mode – Timing mode – Remote
mode (Remote mode is not applicable to this
model)
LED Icon
Icon Description
Clock
Week (1 to 7)
P mode (P1 to P7)
Temperature
Comfort mode
Economy mode
Defrost mode
Timing mode
Remote mode
Anti-scald
Open window detection
24
Icon Description
Child lock
Heating
Comfort mode
Setting the temperature in the daytime,available tem-
perature range 7 °C... 30 °C. Default temperature is
19 °C.
Economy mode
Setting the temperature in the night, available tem-
perature range 7 °C... 30 °C. The Max temperature
shall not exceed the comfortable temperature.Default
temperature is 15.5 °C.
– Press [+] or [–] to set the temperature, press [+]
to increase the temperature.
Defrost mode
Setting the temperature at 7 °C, the unit will turn on at
below 7 °C and it will turn off at above 7 °C.
Timing mode
First time use or long time no-use the radiator (or
power failure), end user have to set present time and
week.
Set time and week:
► P. 11, item 2
– To enter timing mode, press model icon [ ] 5s
untill hour set [00] flashes.
► P. 11, item 3
– Press [+] and [–] to set hour, if no operation for
30s, it will jump to minute setting.
► P. 11, item 4
– Short press mode icon [ ] untill minute [00]
flashes, then press [+] and [–] to adjust. if no
operation for 30s, it will jump to week setting.
► P. 11, item 5
– Short press mode icon [ ] untill week [1]
flashes, then press [+] and [–] to choose week-
day.
• 1 = Mon, 2 = Tue, 3 = Wed, 4 = Thu, 5 = Fri, 6 =
Sat, 7 = Sun.
– After setting, short press mode icon [ ] and
jump to P mode. if no operation for 30s, it will
jump to P mode setting.
► P. 11, item 6
– Short press [+] and [–] to choose mode (P1–P7).
► P. 3, item 7
– Assign P mode for Monday to Sunday, then press
model icon [ ] returning to timing mode.
Noted:
► P. 11, item 8
Icon Description
Heating state is on
Comfort mode is on
Heating