Subscribe to Our Youtube Channel
Related Manuals for HOMCOM 820-260V80
Summary of Contents for HOMCOM 820-260V80
- Page 1 IN221000594V02_US 820-260V80 Electric oil filled heater IMPORTANT, RETAIN FOR FUTURE REFERENCE: READ CAREFULLY USING INSTRUCTION...
- Page 2 READ AND SAVE THESE INSTRUCTIONS READ CAREFULLY BEFORE ATTEMPTING TO ASSEMBLE, INSTALL, OPERATE OR MAINTAIN THE PRODUCT DESCRIBED PROTECT YOURSELF AND OTHERS BY OBSERVING ALL SAFETY INFORMATION FAILURE TO COMPLY WITH INSTRUCTION COULD RESULT IN PERSONAL INJURY AND/OR PROPERTY DAMAGE RETAIN INSTRUCTIONS FOR FUTURE REDERENCE IMPORTANT INSTRUCTIONS When using this appliance, basic precautions should always be followed to reduce...
- Page 3 16.Prohibited the use of automatic power program, timer or any other device to use the heater. 17.Do not put hands, sticks and other objects inserted into the apertures of the heater, to prevent accidents. 18.When using the heater, in order to avoid burns, do not let bare skin in direct contact with electric heating The surface.
- Page 4 Product structure BUTTONS CASTORS Figure 1 Product Structure INSTRUCTIONS FOR USE 1.INSTALLATION METHOD: Remove the heater and all parts from the packaging box. (1) Place the heater upside down, then place the castors onto the bottom using the wing nuts and U-screw (fig. 2). (2) Place the heater upright, so it is in the correct position.
- Page 5 2. What to check before using: (1) Ensure the power cord is not damaged. (2) Ensure the power source matches the electrical requirements stated on the heaternameplate. Also make sure that it has safety grounding - if not, the outlet must be replaced.
- Page 6 4. When the heater is in eco mode, the temperature can be set within the range of 15-35 ℃. The heater will intelligently control the on-off of the heating pipe according to the setting temperature and NTC probe temperature. And the setting temperature will automatically decrease by 1℃...
- Page 7 ANTI-FROST FUNCTION: 1.In the standby state, the mid-range heating is automatically turned on when the NTC temperature is lower than 5℃ (41°F), and when the NTC temperature is higher than 7℃ (45°F), the heating is stopped and returned to the standby state. 2.When the frost protection function is turned on, the ON/STANDBY key become highlight and flashes at a frequency of 2 seconds per time, and the display window flashes “7℃...
Need help?
Do you have a question about the 820-260V80 and is the answer not in the manual?
Questions and answers