Table of Contents
Advertisement
Disassembly
Removing and Replacing the Camera Assembly
G
26
1.
Remove the battery cover, battery, USIM, antenna, rear housing, and trans-
ceiver board assembly, flip assembly cover, and CLI lens cover as described in
the procedures.
The flexible printed cable (FPC) (flex) is easily damaged. Exercise extreme care when
handling.
2.
Unlock the ZIF connector and remove the camera assembly flex connector.
3.
Carefully lift the camera assembly and flex out of the flip assembly
(see Figure 13).
Camera Assembly
Figure 13. Camera Assembly Removal
4.
To replace, carefully press the camera assembly into its slot in the flip
assembly.
5.
Insert the end of the camera assembly flex cable into its slot in the ZIF
connector on the flip display assembly. Avoid damage to the flex cable.
6.
Replace the flip assembly cover, transceiver board, rear housing, antenna,
USIM, battery, and battery cover as described in the procedures.
May 09, 2007
Camera Flex
ZIF Connector
V3xx
6809505A64-A
Advertisement
Table of Contents
