Table of Contents
Advertisement
Compass
The Compass tool creates a circle with a radius equal to the length of an existing segment or the
distance between two points.
Creating a circle using Compass
1.
Select Compass from the Construct toolbox.
2.
Create or select two points or select a segment to
define the radius of the circle.
3.
Create or select the center point of the circle.
Modifying a circle created using Compass
Modify the radius by dragging one of the defining
endpoints.
Translate the compass circle by dragging the center
point.
7-8
Chapter 7: Using the Construct Toolbox
Select a segment.
This segment
Select a center point.
Copying permitted provided TI copyright notice is included
© 1997, 1999 Texas Instruments Incorporated
Advertisement
Table of Contents
