Segment - Texas Instruments Cabri Geometry II Manual Book

For macintosh, windows, and ms-dos

Table of Contents

The Segment tool creates a segment between two endpoints.

Note: You can limit the slope of the segment to 15-degree increments by pressing the

when creating the segment.

Creating a segment

Select Segment from the Lines toolbox.

Click to create or select the initial endpoint of the

segment.

Move the pointer to the location for the final

endpoint of the segment, and click to create or select

the final endpoint.

Example

Select the initial point.

Note: See " Regular Polygon" in this chapter for more information on creating the regular pentagon

in the above figures.

Modifying a segment

Change a segment by dragging either endpoint.

Translate a segment by grabbing away from the

endpoints, and dragging it.

5-4

Chapter 5: Using the Lines Toolbox

Point to the object.

This point

This polygon

Copying permitted provided TI copyright notice is included

key

SHIFT

Create the initial point.

Create the final point.

Table of Contents