Table of Contents
Advertisement
Change the slope of a line by selecting the Pointer tool.
Then using the Pointer :
4
To change a line constructed with a single point,
grab the line away from the point and drag. Press
the
SHIFT
increments.
4
To change a line constructed with two basic
points, drag either of the points.
4
Changing a line constructed with a dependent
point is relative to the object to which it is
attached. You may drag the object or the point,
depending on the construction.
Example
Create a point.
Copying permitted provided TI copyright notice is included
© 1997, 1999 Texas Instruments Incorporated
key to constrain the slope to 15-degree
Create a point.
Chapter 5: Using the Lines Toolbox
The line is attached to a side of the
triangle and the opposite vertex.
5-3
Advertisement
Table of Contents
