Table of Contents
Advertisement
Installing Cabri Geometry II on a network (continued)
Macintosh and DOS
1. Install Cabri Geometry II on the network server using the instructions given on the previous
page.
2. Run the program from the server the first time, and enter the requested information.
3. To run Cabri Geometry II on each network client, go to the directory on the network server
where the Cabri Geometry II application is installed. Macintosh users may double-click on
the Cabri II icon; DOS users may run Cabri2.exe to start the program.
The procedure described below, for Windows users, allows multiple client computers to run Cabri
Geometry II using the application software installed on the network server. Each client computer
is provided with the necessary system files to run Cabri Geometry II and a shortcut icon that is
linked to the application file on the network server.
Windows 3.1 and Windows 95
1. Install Cabri Geometry II on the network server using the instructions given on the previous
page. In the Select Destination screen, you must select a directory that will be accessible from each
client computer on the network.
2. Temporarily copy setup.exe and setup.w02 from the installation diskettes to the same directory in
which you installed Cabri Geometry II in step 1.
3. On each network client, go to the directory on the network server that contains setup.exe and
double-click to on this file to run the setup program.
4. In the Select Destination Directory screen, click on the Browse button and select the same directory
that you used in step 1. Make sure the correct directory is displayed at the top of the window.
You may edit the path, if necessary, and then click on OK . Ignore the message that the directory
already exists.
5. In the Select Components screen, deselect the first three components. The installation program
will determine if the fourth component is necessary for Windows 3.1x users.
6. When Cabri Geometry II has been installed on all client computers, delete the two files that
were temporarily copied to the network server in step 2.
Starting Cabri Geometry II
Macintosh
You can use one of four methods to start the
software on a Macintosh:
¦ Use Open in the Finder .
¦ Double-click on the Cabri II icon.
¦ Double-click on any Cabri Geometry II
construction file, tool configuration file, or
macro file.
¦ Drag and drop any construction file onto
the Cabri II icon (System 7 users only).
Windows
Double-click on the Cabri II icon.
Copying permitted provided TI copyright notice is included
© 1997, 1999 Texas Instruments Incorporated
DOS
Type
and press
CABRI
ENTER
prompt directory where the Cabri Geometry II
files are located.
(Optional) Add the Cabri directory to your DOS
path to open Cabri Geometry II from any
directory.
Chapter 1: Learning the Basics
from the DOS
1-3
Advertisement
Table of Contents
