Texas Instruments Cabri Geometry II Manual Book page 33

Save as...
The Save as ... command generates a dialog box for saving and naming the construction in the active
drawing window. The Save as dialog box provides the interface for saving a new file, saving a file to
a new file name, file type, or location, or saving an existing file. Enter the information requested in
the dialog box to save the file.
For the Macintosh only, you can save the file as a text file if you wish to view its contents with
another program. For example, you can copy data in the Cabri Geometry II table to word
processing or spreadsheet files for further analysis using this method.
Revert...
The Revert... command returns the construction to its most recently saved version. This feature is
useful if you make modifications to your file that you later want to disregard. Revert is especially
useful when demonstrating a construction in the classroom.
Show Drawing...
The size of the drawing window in which you build a geometric construction is one meter by one
meter. Show Drawing/Show Page lets you view this entire region. The entire figure, with the exception
of text or measurement, is displayed in the following dialog box shown below.
A small window represents the portion of your construction that is visible on your computer
screen. The construction cannot be manipulated at this stage, but you can position the window
anywhere within the one-square-meter limits of the construction. Drag the window to move it to
a new section of your construction. Click OK or Cancel to accept or cancel the operation.
4
For the Macintosh, the visible part of your construction can also be moved by clicking on the
scroll bars or by dragging the drawing window while pressing the
key changes the pointer to the open hand ( cursor; pressing the mouse button and
COMMAND
the
COMMAND
method without accessing the Show Drawing/Show Page command.
4
For the DOS versions, the visible part of your construction can also be moved by dragging the
drawing window with the grasping hand ) cursor. Moving the pointer to the drawing window
changes the pointer to the open hand ( cursor; pressing the left mouse button changes the
pointer to the grasping hand ) cursor. You can perform either method without accessing the
Show Drawing/Show Page command.
4
For the Windows version, the visible part of your construction can be moved by also clicking
on and then dragging the drawing window.
Page Setup...
(Macintosh, Windows)
The Page Setup... command lets you specify the paper size and orientation (landscape or portrait),
as well as other options that vary according to the printer.
Note: Cabri Geometry II prints figures to scale. That is, a triangle in your construction will be
printed exactly as specified, preserving the length of the sides and the measurement of the angles.
If you change the Reduce or Enlarge option from 100%, the exact size of the figure will not be
preserved.
Copying permitted provided TI copyright notice is included
© 1997, 1999 Texas Instruments Incorporated
Show Page...
(Macintosh, DOS),
key changes the pointer to the grasping hand ) cursor. You can perform either
(Windows)
COMMAND
Chapter 2: Using the Menus
key. Pressing the
2-3