Table of Contents
Advertisement
Parallel Line
The Parallel Line tool creates a line that passes through a point and is parallel to a selected linear
object (line, segment, ray, vector, or side of a polygon).
Creating a parallel line
1.
Select Parallel Line from the Construct toolbox.
2.
Point to the line, segment, ray, vector, or side of a
polygon that will be parallel to the constructed line
and click to select.
3.
Designate the point through which the parallel line
will pass.
Note: The order of steps 2 and 3 may be reversed.
Modifying a parallel line
Move a parallel line by dragging the point through
which it passes.
The line cannot be altered directly because it is, by
definition, a dependent object.
Example
Select a linear object.
Parallel to this side of the polygon
Copying permitted provided TI copyright notice is included
© 1997, 1999 Texas Instruments Incorporated
Create a point, and the
parallel line is constructed.
Chapter 7: Using the Construct Toolbox
Select a linear object.
Parallel to this side of the triangle
Select a point.
By this point
A dependent line is created.
7-3
Advertisement
Table of Contents
