Maintenance, Service And Storage; Inspection - Falltech APEX WPFRD User Instruction Manual

8. Connect the snap hook back into the Adjuster Eye. See Figure 31 above.
9. Feed the eye of the rope through the Fixed Bent D-ring and reconnect the Body Belt Carabiner to
the end of the rope. See Figure 32. Final assembly should be a mirror image of the original right-
handed configuration. See Figure 33 below for final left-handed layout.
Figure 32: Rope Installation
5.6 Pole Top Rescue:
To perform traditional pole top rescue on an impacted and loaded device, either the Web Strap or the
Rope can be cut to release the victim.
5.6.1 Pole Top Rescue - Web Strap:
There are two acceptable locations to cut: (1) Between the Web Strap Cleat and the Bent D-ring or (2)
directly behind the Adjuster.
5.6.2 Pole Top Rescue - Rope:
Cut anywhere between the Rope Adjuster and the Body Belt Carabiner. Note: When cutting the rope,
the web strap component will separate from the rope and fall to the ground.

6.0 Maintenance, Service and Storage

6.1 Maintenance:
Ensure the WPFRD is kept free of excess paint, grease, dirt or other contaminants as this may cause the
various mechanisms to malfunction. Clean the exterior of the unit as required with a detergent/water
solution. After cleaning, lay out or hang all components to allow the unit to air dry. Lubricate parts as
needed.
• DO NOT use heat to dry.
• DO NOT attempt to disassemble the WPFRD in manners other than those described in this
manual.
6.2 Service:
This unit is not serviceable or repairable. Replacement components may be purchased as they are
removed from service.
6.3 Storage:
Hang the WPFRD in a cool, dry, clean environment out of direct sunlight. Position the WPFRD so excess
water can drain out. Avoid exposure to chemical or caustic vapors. Thoroughly inspect the WPFRD after
any period of extended storage.

7.0 Inspection

7.1 Pre-Use User Inspection:
Perform an inspection before each use in accordance with the recommendations in Table 1 below.
7.2 Inspection Frequency:
Inspection is required before each use. Inspection by a Competent Person other than the user is
required annually.
13
Figure 33: Final Left-Handed Layout