Maintenance, Service, And Storage - Falltech FT-R 721530LE User Instruction Manual

5.6.3 Inspect the Cable:
The SRD lifeline is steel cable, and subject to certain hazards. Inspect the lifeline before each use for
the conditions as described in Section 7.
5.7 Using the SRD:
Do not use the SRD if inspection shows damage or any malfunction. Don the FBH in accordance
with the FBH manufacturer's instructions. Follow the instructions contained in this manual and on
the labels. Failure to follow instructions may result in serious injury or death. Connect the leg end
carabiner to the dorsal D-ring on the FBH. Ensure the carabiner closes and locks. Attach the housing
carabiner to the chosen anchorage and ensure the carabiner closes and locks. Ensure all connections
are compatible. Normal operation will allow the working length of the lifeline to extend and retract as
the worker moves about. A certain amount of tension must remain on the cable at all times to ensure
proper operation of the internal brake. Do not allow the lifeline to become slack. If the lifeline becomes
slack, remove the SRD from service for inspection. See Section 7.
Avoid sudden or quick movements during the normal work operation, as this may cause the SRD brake
to engage and possibly cause loss of balance and injury or death.
If a fall occurs, the brake will engage and lock the lifeline. The EA will deploy to arrest the fall and limit
arrest forces on the user.
•
DO NOT extend the lifeline past the operational limit.
•
DO NOT allow one SRD lifeline to become tangled or twisted with another SRD lifeline during use.
•
DO NOT allow any lifeline to pass under arms or between legs during use.
•
DO NOT clamp, knot, or prevent the lifeline from retracting or being taut.
•
DO NOT lengthen the SRD by connecting a lifeline or similar component.
•
DO NOT allow the lifeline to remain outside the housing when not in use.
•
DO NOT allow the lifeline to freewheel back into the housing. Use a tag line to maintain tension
and rewind the lifeline during periods of inactivity. Use the tag line to retrieve the leg end
connector for the next use.
•
DO NOT leave the tag line connected to the leg end connector when using the SRD for fall
protection.
5.8 After A Fall:
A fall event over an edge may require special rescue equipment and measures. Ensure a written
rescue plan, method and system is in place and readily available to all users for rapid response. Ensure
all users are trained in rescue procedures. If a fall event occurs, remove it from service, and store it
separately. Remove from service any unit that has been subjected to fall arrest forces or that exhibits
damage consistent with such forces. For questions, contact FallTech.

6.0 Maintenance, Service, and Storage

6.1 Maintenance:
Ensure the SRD is kept free of excess paint, grease, dirt or other contaminants as this may cause to
cable or retracting mechanism to malfunction. Ensure no debris enters the housing through the cable
access port. Clean the exterior of the unit as required with a detergent/water solution. Avoid water
other corrosion causing elements to enter the housing. After cleaning, pull the lifeline all the way out,
allow the unit to air dry, then retract the lifeline into the unit. Do not allow the lifeline to freewheel back
into the housing. Clean labels as required.
•
DO NOT use heat to dry.
•
DO NOT attempt to disassemble the SRD.
6.2 Service:
If service is required for any reason; inspection failure, impact loaded, any type of malfunction, tag
the unit as "UNUSABLE", store separately, and contact FallTech at 800-719-4619 to receive a Return
Authorization number or to locate the nearest FallTech Service Center. The SRD is not user repairable.
Only the manufacturer, or a repair facility authorized in writing, may make repairs to the SRD. This
SRD is designed to be used installed in an anchor cradle or attached overhead. While it may be used
horizontally on a flat surface, the user may encounter a situation where the lifeline will not retract
all the way due to misalignment and bunching up on the drum. If this happens, hang the SRD from a
height sufficient to allow the full working length of the lifeline to be pulled off the drum, then allow
the SRD to retract the lifeline completely. Maintain tension on the lifeline. Use a tag line if necessary.
16