Maintenance, Service And Storage; Inspection - Falltech FT-Lineman Pro 8050 User Instruction Manual

Body belt
Table of Contents

Advertisement

5.4 Installation:
5.4.1 Connecting the Device to the Body Belt:
Connect the two Body Belt Carabiners to the Primary Connecting Links of the Body Belt as show in
Figure 4 below.
Note: The triple locking oval Body Belt Carabiners can be connected with the gate openings facing
inward or outward. Inward facing gates as shown in Figure 4 makes connecting and disconnecting
easier and prevents materials/equipment from interfering with the gates.

6.0 Maintenance, Service and Storage

6.1 Maintenance:
Ensure the FT-Lineman Pro Body Belt is kept free of excess paint, grease, dirt or other contaminants as
this may cause the various mechanisms to malfunction. Clean the exterior of the unit as required with
a detergent/water solution. After cleaning, lay out or hang all components to allow the unit to air dry.
Lubricate parts as needed.
• DO NOT use heat to dry.
• DO NOT attempt to disassemble the Body Belt in manners other than those described in this
manual.
6.2 Service:
This unit is not serviceable or repairable.
6.3 Storage:
Hang the Body Belt in a cool, dry, clean environment out of direct sunlight. Position the Body Belt so
excess water can drain out. Avoid exposure to chemical or caustic vapors. Thoroughly inspect the Body
Belt after any period of extended storage.

7.0 Inspection

7.1 Pre-Use User Inspection:
Perform an inspection before each use in accordance with the recommendations in Table 1 below.
7.2 Inspection Frequency:
Inspection is required before each use. Inspection by a Competent Person other than the user is
required annually.
7.3 Inspection Checklist:
Use Table 1: Guidelines for Body Belt Inspection to inspect the FT-Lineman Pro. Remove from service
any belt that fails inspection.
7.4 Inspection Results:
If an inspection reveals defects in or damage to the equipment, inadequate maintenance or activated
fall indicators, remove the equipment from service. If any component fails inspection, remove from
service immediately. Body Belts involved in a fall may be returned to service after passed inspection by
a Competent Person other than the user.
7.5 Inspection Document:
Record inspection results on the Inspection Record provided below or on a similar document.
7
Figure 4: Connecting Device to Body Belt

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ft-lineman pro 8050qc

Table of Contents