Page 2
If needed you can reach us by sending an English E-mail to: service@fromm-stretch.com. Your question will be answered directly by us, or forwarded to one of our service hubs in the area for which the service request has been done. Obviously you can also take a direct contact with the supplier of your machine.
Page 6
This manual is only intended for a semi-automatic pallet stretch wrapping machine, mentioned at page one, as delivered by FROMM Stretch Wrapping Division. FOR EVERYTHING IN THIS MANUAL IS VALID, IF APPLIED! THE ORIGINAL, SIGNED FACTORY MANUAL HAS TO REMAIN CLOSE TO THE MACHINE, TOGETHER WITH THE MACHINE ELECTRICAL PLAN AND INVERTER MANUALS.
The following conditions have always to be satisfied, unless otherwise indicated in other instructions in this manual. This wrapping machine has been delivered by FROMM Stretch Wrapping Division and may only be applied for wrapping of pallets / products which meet the requirements as mentioned in the description of the machine in chapter TECHNICAL DATA.
Page 12
FROMM FS4.1349-Manual-32.12XX.XXX.V04-EN08_R2.doc EXPLANATION IDENTIFICATION LABEL An identification label with the following information has been mounted at the backside of mast. Name of the manufacturer : FROMM Slovakia a.s. Type : Machine type. Serialnr. : Production number of manufacturer. Voltage : Supply voltage.
Page 19
Fig. 15 Very important guidelines that must strictly be complied with. Otherwise machine operators could be at risk, the consequence of which would be the voiding of any form of warranty and liability on behalf of FROMM WRAPPING SYSTEMS. Figure 16: Operations that must never be performed.
3x beep / pause E4: CLAMP PROTECTION 4x beep / pause E5: TABLE SAFETY DEVICE 5x beep / pause ES: SERVICE BY FROMM ENGINEER REQUESTED Fig.1 ALARM RESET Clear the fault, push the RESET button if it is necessary to restart the cycle.
Page 31
Main operating mode selection (Small light on, indicates the selected function) Automatic / Manual Double wrapping mode wrapping ascent / descent Below parameters have to be sett at first installation. (Can only be changed by FROMM service) Single wrapping Single wrapping cycle, ascent only cycle, ascent only MANUAL RETURN...
Page 34
On the button the light switches ON when the function has been selected. Display indication values of the selected settings Or PA – Parameters for FROMM Engineers only Or ES – Maintenance counter elapsed!! Machine maintenance by FROMM service required!! Check value maintenance counter under information button.
Main operating mode selection automatic mode (If small light = ON, indicates the selected function) Auto/manual mode Double wrapping wrapping ascent / descent Below parameters have to be sett at first installation. (Can only be changed by FROMM service) Single wrapping Single wrapping cycle, cycle, ascent only...
3x beep than pause (repeated sequence) CLAMP PROTECTION 4x beep than pause (repeated sequence) TABLE SAFETY DEVICE 5x beep than pause (repeated sequence) ES: SERVICE BY FROMM ENGINEER REQUESTED ALARM RESET After having cleared the fault, push the RESET button...
Page 46
(EC machinery directive 2006/42/EC - Annex IIA) The Supplier (manufacturer): FROMM SLOVAKIA a.s. Priemyselná 5885 SK-901 01 Malacky (SLOVAK REPUBLIC) Agent: FROMM Wrapping Systems S.r.l. Via del Lavoro 21 IT-37013 Caprino V.se (VR) (ITALY) Declares, under its responsibility, that the product: Model: FS33x Machine type: Serial no.:...
Need help?
Do you have a question about the FS33 Series and is the answer not in the manual?
Questions and answers