Toshiba MMY-MUP0801HT8P-TR Service Manual page 277

No. Part
3
Heat 3) Cut the pipes at the heat exchanger (Fig.6, Fig.7).
exchanger
(continued)
<8 to 14HP>
4) Remove the heat exchanger while draw it upward or at
rear side
<8 to 14HP (Fig.8)> : M5 × 10, 2 pcs
<16 to 24HP (Fig.9)> : M5 × 10, 8 pcs
2. Attachment
Carry out installation by following reverse procedure in the
detachment 1) to 4).
Work procedure
(1) Header pipe at the gas
side (Main heat exchanger)
(3) Header pipe at the gas
side (Sub-heat exchanger)
(2) Distributor at the liquid
side (Main heat exchanger)
(4) Distributor at the liquid
side (Sub-heat exchanger)
Fig. 6
M5×10, 2 pcs
Fig. 8
- 277 -
Remarks
<16 to 24HP>
(1) Header pipe at the gas
side (Main heat exchanger)
(2) Distributor at the liquid
side (Main heat exchanger)
(3) Header pipe at the gas
side (Sub-heat exchanger)
(4) Distributor at the liquid
side (Sub-heat exchanger)
Fig. 7
M5×10, 8 pcs
Fig. 9