Table of Contents
Advertisement
4.3.4
OPERATION
ALL MODELS
1)
Ensure all red emergency stops are out.
2)
Turn key switch at ground control station to Platform (fully clockwise).
3)
Set the speed selector control as required. Speed I gives minimum function control speed and
Speed III allows maximum function control speed.
Note: If the ambient air temperature is <10°C it is recommended to use Speed II until the machine
has warmed up sufficiently.
4)
Depress the footswitch or push and hold green power button on the platform control panel.
5)
Select one or more functions and operate the appropriate proportional paddles (levers) in full
accordance with manufacturer's Operating and Safety Manual.
6)
To return control to the base controls, turn base control key-switch to the Ground position
(Centre).
7)
When not in use return booms to the stowed position. Turn base control key-switch on the
ground control station to the fully anti-clockwise OFF position and chock wheels.
English/USA – 05/15
Original instructions
NEVER START THE NIFTYLIFT IF YOU SMELL PETROL (GASOLINE), LIQUID
PROPANE OR DIESEL. THESE FUELS ARE FLAMMABLE.
BEFORE OPERATING THE NIFTYLIFT ENSURE THAT EACH OPERATOR HAS READ
AND FULLY UNDERSTOOD THE OPERATING MANUAL. FAILURE TO DO SO MAY
RESULT IN DEATH OR SERIOUS INJURY.
ALWAYS ENSURE THE AERIAL PLATFORM IS ON A FIRM LEVEL SURFACE AND
THE AREA IS FREE OF ANY OVERHEAD OBSTRUCTIONS.
ENGAGING THE RED EMERGENCY STOP BUTTON WILL SHUT DOWN THE
ELECTRIC CIRCUIT PREVENTING OPERATION OF ANY FUNCTION.
Height Rider/SP Series
Operating & Safety Instructions
29
Advertisement
Table of Contents
