Maintenance/Changing The Filter; Troubleshooting - Silvercrest 331382 1907 Operating Instructions Manual

Maintenance/changing the filter
After 4 – 6 months or approximately 100 cleaning cycles (one cycle corresponds
to one water tank filling), you will need to change the filter 7. Please contact
our Service Department for replacement filters.
RISK OF ELECTRIC SHOCK!
Before changing the filter 7, always pull out the mains plug!
►
1) To remove the filter 7, first remove the water tank 8 from the appliance.
2) Pull the filter 7 upwards out of the appliance.
3) Insert the new filter 7.
4) Replace the water tank 8.

Troubleshooting

Programme
The appliance is not working.
The appliance
produces no steam.
The pump makes unusually
loud noises.
A whitish edge forms on the
floor when the appliance stops
briefly during operation.
SDM 1500 D2
Possible causes
The plug is not
connected.
The "Steam" button r
has not been pressed.
There is no water in the
water tank 8.
The filter 7 is blocked.
No steam setting has
been selected.
There is no water in the
water tank 8.
Lime has collected.
Possible solutions
Connect the appliance to a
mains power socket.
Press the "Steam" button r.
Fill the water tank 8 with tap
water.
Change the filter 7.
Use the MODE button e to
select the desired level of steam.
Fill the water tank 8 with tap
water.
Wipe the limescale away with a
damp cloth. If necessary, add a
little descaler onto the cloth.
GB │ MT │
31 ■