Maintenance/Changing The Filter; Troubleshooting - Silvercrest SDM 1500 D2 Operating Instructions Manual

Maintenance/changing the filter

After 4 – 6 months or approximately 100 cleaning cycles (one cycle corresponds
to one water tank filling), you will need to change the filter 7 . Please contact
our Service Department for replacement filters .
RISK OF ELECTRIC SHOCK!
► Before changing the filter 7, always pull out the mains plug!
1) To remove the filter 7, first remove the water tank 8 from the appliance .
2) Pull the filter 7 upwards out of the appliance .
3) Insert the new filter 7 .
4) Replace the water tank 8 .

Troubleshooting

Programme
The appliance is not working .
The appliance
produces no steam .
The pump makes unusually
loud noises .
A whitish edge forms on the
floor when the appliance stops
briefly during operation .
SDM 1500 D2
Possible causes
The plug is not
connected .
The "Steam" button r
has not been pressed .
There is no water in the
water tank 8 .
The filter 7 is blocked .
No steam setting has
been selected .
There is no water in the
water tank 8 .
Lime has collected .
Possible solutions
Connect the appliance to a
mains power socket .
Press the "Steam" button r .
Fill the water tank 8 with tap
water .
Change the filter 7 .
Use the MODE button e to
select the desired level of steam .
Fill the water tank 8 with tap
water .
Wipe the limescale away with a
damp cloth . If necessary, add a
little descaler onto the cloth .
GB │ IE
31 ■
│