Silvercrest 331382 1907 Operating Instructions Manual page 32

NOTE
► We recommend the high steam level especially for moisture- and
heat-resistant floor coverings, such as tiles.
► We recommend the low steam level especially for moisture- and
heat-sensitive floor coverings, such as parquet flooring.
7) Press the "Steam" button r. The appliance starts generating steam and,
after a short time, steam is emitted through the pad 6/o.
8) Wipe over the desired area.
NOTE
Once the water tank 8 has been pumped empty, the pump will continue
►
running a little while until the empty water tank 8 is indicated by the
simultaneous flashing of the red control lamp q, the green control lamp w
and POWER control lamp 0.
If the water tank 8 becomes empty during use:
–
Press the "Steam" button r again to stop steam production.
–
Set the on/off switch u to "O".
–
Remove the water tank 8, fill it and replace the water tank 8 as
described in the section "Filling with water".
–
Set the on/off switch u to "I".
–
Select the desired steam level as described above and press the
"Steam" button r.
9) When you are finished treating all of the surfaces, press the "Steam"
button r to stop steam production.
10) Set the on/off switch u to "O". The POWER control lamp 0 goes out.
11) Remove the power plug from the mains power socket.
NOTE
► If you see streaks on the floor after cleaning with the appliance, this may be
due to the previously used cleaning fluids. Simply clean the floor again
using the steam mop. The smears should now be gone.
SDM 1500 D2
GB │ MT │
29 ■