Handling And Operation; Filling With Water - Silvercrest 295774 Operating Instructions Manual

Handling and operation

This section provides you with important information on handling and using the
appliance.

Filling with water

CAUTION – PROPERTY DAMAGE!
► Never operate the appliance without water in the water tank
The pump could overheat and be damaged!
1) Push the "Water tank" release button
pull the water tank
movement.
2) Turn the water tank
3) Fill the water tank
NOTE
If the mains water in your location is rated as hard, it is recommended that
you mix the mains water with some distilled water. Otherwise, the jets for
the steam blast function could calcify (become blocked) prematurely.
To extend the optimal steam blast function, mix mains water with
distilled water according to the table:
Water hardness
The water hardness level can be queried at your local water works.
4) Attach and hand-tighten the clamp.
5) Turn the water tank
First fit the lower part into the main unit
device. Push it firmly into place so that the water tank
place and sits firmly on the main unit
SDM 1500 C2
towards the rear and off the appliance with a tilt
and unscrew the cap.
with tap water up to the MAX mark.
very soft/soft
medium
hard
very hard
around again and place it back onto the main unit
downwards and simultaneously
Ratio of distilled
water to
tap water
0
1:1
2:1
3:1
and then flip the top part into the
.
!
:
audibly clicks into
GB │ MT │
45 ■