Connect A Cisco Standard Base With The Y-Cable - Cisco 7800 Series User Manual

CISCO 7800 SERIES
Figure 11: Standard Headset Connection
Caution Failure to press the cable into the channel in the phone can damage the printed circuit board inside the phone.
The cable channel reduces the strain on the connector and the printed circuit board.
Procedure
Plug the headset into the headset jack on the back of the phone. Press the cable into the cable channel.

Connect a Cisco Standard Base with the Y-Cable

You can connect the standard base to your phone with the included Y-cable. But note that the Y-cable has
two RJ-type connectors - one for the auxiliary or AUX port, and one for the headset port. You can distinguish
between the two connectors by their size, as the AUX port connector is slightly larger than the headset port
connector.
Caution
Failure to press the cable into the channel in the phone can damage the printed circuit board inside the phone.
The cable channel reduces the strain on the connector and the printed circuit board.
Procedure
Step 1
Plug the smaller connector into the headset jack that is located on the back of the phone.
Press the cable into the cable channel.
Step 2
Plug the larger cable into the AUX port located next to the headset port.
GoMomentum.com 69
USER GUIDE
888.538.3960