Parking Brake Switch - Hitachi ZW140-6 Operator's Manual

Parking Brake Switch

d
WARNING:
 To prevent accidents due to running away of the
machine, after parking the machine or before
leaving the machine, be sure to apply the parking
brake.
 Never apply the parking brake by operating parking
brake switch (1) while traveling the machine except
in an emergency. Premature wear and/or damage
to the parking brake may result. After the parking
brake has been applied in an emergency while
traveling the machine, have the parking brake
checked at your authorized dealer.
1. Press the OFF side of parking brake switch (1) to release
the parking brake. Check that parking brake indicator (2)
goes OFF by pressing the switch twice with clicks.
Press the ON side of parking brake switch (1) to apply the
parking brake.
Operate the parking brake after parking the machine on
level ground.
f
NOTE: While running the engine, when the parking brake
is applied with forward/reverse lever (3) in neutral, parking
brake indicator (2) comes ON.
2. While running the engine, when the parking brake
is applied with forward/reverse lever (3) in either
the forward (F) or reverse (R) position, parking brake
indicator (2) comes ON, and the alarm buzzer sounds.
F-N-R display (4) of the monitor display indicates "N" not
"F" and "R". The display will not indicate "F" and "R" until
the parking brake is released.
3. To ensure safe operation, when the engine is stopped,
the parking brake is applied even if parking brake switch
(1) is in the OFF position.
In this case even after the engine is restarted, the
parking brake will not be released. After starting the
engine, push the ON position of parking brake switch (1)
once. Then, push the OFF position parking brake switch
(1) to release the parking brake.
DRIVING MACHINE
4-4
1 3
1
OFF ON
4
MNDB-01-002
MNEC-01-058
2
MPTC-01-019