The Image Is Blurred; The Flash Takes Too Long To Recharge - Sony Cyber-shot RX10 II How To Use Manual

Help Guide
The image is whitish (Flare)./Blurring of light appears on
the image (Ghosting).
When pointing the lens toward the strong light source, excessive light enters the lens and
the image may come out white (flare) or extraneous light (ghost images) may appear on
the image, but this is not a malfunction.
Set up the composition so that you shoot images while avoiding backlit condition.
[304] Troubleshooting

The image is blurred.

Make sure that [SteadyShot] is set to [On].
The picture was taken in a dark location without the flash, resulting in camera-shake. The
use of a tripod or the flash is recommended. [Hand-held Twilight] and [Anti Motion Blur] in
[Scene Selection] are also effective in reducing blur.
[305] Troubleshooting
The monitor darkens after a short period of time passed.
If you do not operate the product for a certain period of time, the product switches to the
power-save mode. The product exits power-save mode when you perform operations
such as pressing the shutter button halfway.
[306] Troubleshooting

The flash takes too long to recharge.

The flash has been fired in succession in a short period. When the flash has been fired in
succession, the recharging process may take longer than usual to avoid overheating of
the camera.
file:///Z|/15-1h_HG/Kaihan_20151021_FV-ZV/Nouhin/Web/4574925122.w/en/print.html[10/27/2015 6:18:47 PM]
Troubleshooting Shooting still images/movies
Troubleshooting Shooting still images/movies
Troubleshooting Shooting still images/movies