Supermicro 8060 User Manual page 92

S S 8060
UPER ERVER
Serial Port2 Mode
The options for this setting are Normal, IrDA SIR-A,. IrDA SIR-B,
ASKIR, Consumer and Raw IR . When set to anything but
Normal, the IR Duplex Mode becomes available and can be set to
either Half or Full .
Onboard Parallel Port
This setting specifies the base I/O port address of the parallel port on the
motherboard. The options are Auto (AMIBIOS automatically determines the
correct base I/O port address), Disabled , 378h , 278h and 38Ch .
Parallel Port Mode
This setting specifies the parallel port mode. The options are
Normal , Bi-Dir, EPP and ECP . When set to Normal, the normal
parallel port mode is used. Use Bi-Dir to support bidirectional
transfers. Use EPP (Enhanced Parallel Port) to provide asymmetric
bidirectional data transfer driven by the host device. Use ECP
(Extended Capabilities Port) to achieve data transfer rates of up to
2.5 Mbps. ECP uses the DMA protocol and provides symmetric
bidirectional communication.
for this option is ECP and the Fail-Safe setting is Normal .
EPP Version
The options are Enabled and Disabled .
Fail-Safe default settings are N/A.
Parallel Port IRQ
This setting specifies the IRQ to be used by the parallel port. The
options are 5 and 7 .
Parallel Port ECP DMA Channel
This setting is only available if the parallel port mode is set to ECP .
The options are 0 , 1 , 2 , 3 , 5 , 6 and 7 .
Onboard IDE
This setting enables the IDE (Hard Disk Drive Controller) device(s) on the
motherboard.
Manual
Serial Port2 Duplex Mode
This setting is enabled by the selection made in the previ-
ous Serial Port 2 Mode setting. This makes the IR Duplex
Mode available, which can be set to either Half or Full .
The options are Enabled and Disabled .
Note: The Optimal default setting
Note: The Optimal and
7-18