Supermicro 8060 User Manual page 80

Supermicro superserver 8060 servers: user guide
Table of Contents

Advertisement

S
S
8060
UPER
ERVER
Enabled
Note: The AMIBIOS Setup can be run at system boot but no
display is given
Pri Master ARMD Emulated as
Pri Slave ARMD Emulated as
Sec Master ARMD Emulated as
Sec Slave ARMD Emulated as
The options for this setting are Auto, Floppy and Hard disk . If set to
Auto, the default emulation type depends on the ARMD drive. The default
emulation type is floppy for LS120, Hard Disk for MO and Hard Disk for
Iomega Zip.
1st Boot Device
2nd Boot Device
3rd Boot Device
The options for the 1st Boot Device are Disabled, 1st IDE-HDD, 2nd IDE-
HDD, 3rd IDE-HDD, 4th IDE-HDD, Floppy, ARMD-FDD, ARMD-HDD,
ATAPI CDROM, SCSI, Network and I
Device are Disabled, 1st IDE-HDD, 2nd IDE-HDD, 3rd IDE-HDD, 4th
IDE-HDD, Floppy, ARMD-FDD, ARMD-HDD, ATAPI CDROM and SCSI .
The options for the 3rd Boot Device are Disabled, 1st IDE-HDD, 2nd
IDE-HDD, 3rd IDE-HDD, 4th IDE-HDD, Floppy, ARMD-FDD, ARMD-HDD
and ATAPI CDROM .
1st IDE-HDD, 2nd IDE-HDD, 3rd IDE-HDD and 4th IDE-HDD are the four
hard disks that can be installed by the BIOS. 1st IDE-HDD is the first
hard disk installed by the BIOS, 2nd IDE-HDD is the second hard disk, and
so on. For example, if the system has a hard disk connected to Primary
Slave and another hard disk to Secondary Master, then 1st IDE-HDD will
be referred to as the hard disk connected to Primary Slave and 2nd IDE-
HDD will be referred to as the hard disk connected to the Secondary
Master. 3rd IDE-HDD and 4th IDE-HDD are not present. Note that the
order of the initialization of the devices connected to the primary and
secondary channels are Primary Master first, Primary Slave second,
Secondary Master third, and Secondary Slave fourth.
Manual
AMIBIOS does not test system memory above 1 MB.
AMIBIOS does not wait up to 40 seconds for a
READY signal from the IDE hard disk drive. If a READY
signal is not received immediately from the IDE drive,
AMIBIOS does not configure that drive. AMIBIOS does not
wait for .5 seconds after sending a RESET signal to the
IDE drive to allow the IDE drive time to get ready again. In
Enabled, the keyboard will be bypassed.
.
0 . The options for the 2nd Boot
2
7-6

Advertisement

Table of Contents
loading

Table of Contents