Table of Contents
Advertisement
S
S
8060
UPER
ERVER
Check
Point
38
39
3A
40
42
43
44
45
46
47
48
49
4B
Manual
Description
Initializing the bus input, IPL, and general devices next, if
present.
Displaying bus initialization error messages.
The new cursor position has been read and saved.
Displaying the Hit <DEL> message next.
Preparing the descriptor tables next.
The descriptor tables are prepared.
mode for the memory test next.
Entered
protected
diagnostics mode next.
Interrupts enabled if the diagnostics switch is on.
Initializing data to check memory wraparound at 0:0 next.
Data initialized.
0:0 and finding the total system memory size next.
The memory wraparound test has completed.
memory size calculation has been completed.
patterns to test memory next.
The memory pattern has been written to extended
memory.
Writing patterns to the base 640 KB memory
next.
Patterns written in base memory.
amount of memory below 1 MB next.
The amount of memory below 1 MB has been found
and verified.
Determining the amount of memory above
1 MB memory next.
The amount of memory above 1 MB has been found
and verified.
Checking for a soft reset and clearing the
memory below 1 MB for the soft reset next.
power on situation, going to checkpoint 4Eh next.
mode.
Enabling
Checking for memory wraparound at
B-4
Entering protected
interrupts
for
The
Writing
Determining the
If this is a
Advertisement
Table of Contents
