Supermicro 7044H-82 User Manual page 26

S S
UPER ERVER 7044H-82R/7044H-X8R/7044H-82 User's Manual
3. Installing CD-ROM and floppy disk drives
Refer to Chapter 6 if you need to reinstall a CD-ROM and/or floppy disk
drive to the system.
4. Check the SCSI disk drives
Depending upon your system's configuration, your system may have one
or more drives already installed. If you need to install SCSI drives, please
refer to Chapter 6.
5. Check the airflow
Airflow is provided by four hot-swap 8-cm chassis fans working in conjunction
with an air shroud. Two 8-cm exhaust fans are also mounted at the rear
of the chassis. The system component layout was carefully designed to
promote sufficient airflow through the chassis. Also note that all power
and data cables have been routed in such a way that they do not block
the airflow generated by the fans. Keep this in mind when you reroute
them after working on the system.
6. Supplying power to the system
The last thing you must do is to provide input power to the system. Plug the
power cord from the power supply unit into a high-quality power strip that offers
protection from electrical noise and power surges. It is recommended that you
use an uninterruptible power supply (UPS). Finally, depress the power on
button on the front of the chassis.
2-10