Control Of A Supply Unit (Lsu) - ABB ACS880-x04 Firmware Manual

Primary control program
Table of Contents

Advertisement

Control of a supply unit (LSU)

General
If the drive has separately-controlled supply and inverter units (also known as line-
side and motor-side converters), the supply unit can be controlled through the
inverter unit. For example, the inverter unit can send a control word and references to
the supply unit, enabling the control of both units from the interfaces of one control
program.
With ACS880 single drives, the two control units are connected at the factory. In
ACS880 multidrives (drive systems with one supply unit and multiple inverter units),
the feature is not typically used.
Communication
The communication between the converters and the drive consists of data sets of
three 16-bit words each. The inverter unit sends a data set to the supply unit, which
returns the next data set to the inverter unit.
The communication uses data sets 10 and 11, updated at 2 ms intervals. Data sets
10 is sent by the inverter unit to the supply unit, while data set 11 is sent by the supply
unit to the inverter unit. The contents of the data sets are freely configurable, but data
set 10 typically contains the control word, while data set 11 returns the status word.
The basic communication is initialized by parameter
will make several parameters visible (see below).
If the supply unit is regenerative (such as an IGBT supply unit), it is possible to send
a DC voltage and/or reactive power reference to it from inverter parameter group
LSU
control. A regenerative supply unit will also send actual signals to the inverter
unit which are visible in parameter group
Settings
• Parameters
01.102...01.164
06.36...06.43
(page 138),
147),
30.101...30.149
word 1
(page 416) and
• Parameter groups
transmit data
(page 377),
control
(page 409).
(page 120),
06.116...06.118
(page 269),
31.120...31.121
96.108 LSU control board boot
60 DDCS communication
62 D2D and DDCS receive data
95.20 HW options word
01 Actual
values.
05.111...05.121
(page 144),
07.106...07.107
(page 281),
(page 428).
(page 364),
Program features 41
1. This
(page 130),
(page
95.20 HW options
61 D2D and DDCS
(page 381) and
94 LSU
94

Advertisement

Table of Contents
loading

Table of Contents