Table of Contents
Advertisement
6-3
System Fans
Four 8-cm fans provide all the cooling needed for the SuperServer 6021F.
It is very important that the chassis top cover is properly installed and
making a good seal in order for the cooling air to circulate properly
through the chassis. See Figure 6-3.
System Fan Failure
The fans run at 3400 rpm. If a fan fails, the ambient air temperature in
the chassis will rise and activate the overheat LED on the control panel.
Replace any failed fan immediately. The hot plug fans will start to
function upon connection to its fan header on the P3TDE6 motherboard.
Replacing System Cooling Fans
1.
Removing a fan:
Remove the chassis cover. Press the tabs on the top of the fan housing
and remove the fan and its housing. The system power need not be shut
down since the fans are all hot-pluggable on the P3TDE6 motherboard.
2.
Installing a new fan:
Replace the failed fan with an identical 8-CM, 12 volt fan (available from
Supermicro). Position the new fan at its proper place in the chassis, by
fitting the fan with its housing onto the fan mounts in the chassis. A
"click" can be heard if the fan in its housing is properly installed. If the
system power is on, the fan will start immediately upon being connected
to its header on the P3TDE6 motherboard, with its hot-changeable fan
feature.
Chapter 6: Advanced Chassis Setup
6-3
Advertisement
Table of Contents
