Table of Contents
Advertisement
5-4
I/O Ports
The I/O ports are color coded in conformance with the PC 99 specification.
See Figure 5-2 below for the colors and locations of the various I/O ports.
Mouse
(Green)
Keyboard
(Purple)
5-5
Installing Processors
!
1.
Installing the FCPGA processors:
The P3TDE6 has two 370-pin sockets, which support single or dual Intel
®
Pentium
III FCPGA 500 MHz-1.26+ GHz processors and single or dual
low power Pentium
MHz. Lift the lever on the FCPGA socket and insert the processor (with
the heat sink attached) keeping the notched corner oriented toward pin
one on the socket. Make sure the processor is fully seated in the socket
and then close the lever. You can also install a single processor on the
motherboard without changing any jumper settings. (See Figure 5-3 for
views of a 370-pin FCPGA socket before and after processor installa-
tion.)
USB
COM1
Ports
(Black)
Figure 5-2 P3TDE6 Rear Panel I/O Ports
Avoid placing direct pressure to the top of the pro
cessor package.
and always remove it before adding, removing or
changing any hardware components.
®
III processors at front bus speeds of 100 and 133
Parallel Port
(Burgundy)
COM2
(Turquoise)
Always connect the power cord last
5-5
Chapter 5: Installation
Ethernet
Port
(Black)
Advertisement
Table of Contents
