Table of Contents
Advertisement
Warnings
ELECTRIC SHOCK HAZARD
Explosive Atmospheres or Hazardous (Classified) Locations Models (hard wired for permanent
connection):
This equipment must be grounded. Improper grounding, setup, or usage of the system can cause
electric shock.
•
Turn off and disconnect power at main switch before disconnecting any cables and before servicing
or installing equipment.
•
Connect only to grounded power source.
•
All electrical wiring and repairs must be done by a qualified electrician and comply with all local
codes and regulations.
•
Do not expose to rain. Store indoors.
Ordinary Locations Models (cord and plug connection)
This equipment must be grounded. Improper grounding, setup, or usage of the system can cause
electric shock.
•
Turn off and disconnect power cord before servicing equipment.
•
Connect only to grounded electrical outlets.
•
Only use 3-wire extension cords for 2-phase models. Only use 4-wire extension cords for 3-phase
models.
•
Ensure ground prongs are intact on power and extension cords.
•
Do not expose to rain. Store indoors.
•
Wait five minutes after disconnecting power cord before servicing.
EQUIPMENT MISUSE HAZARD
Misuse can cause death or serious injury.
•
Do not operate the unit when fatigued or under the influence of drugs or alcohol.
•
Do not exceed the maximum working pressure or temperature rating of the lowest rated system
component. See Technical Specifications in all equipment manuals.
•
Use fluids and solvents that are compatible with equipment wetted parts. See Technical
Specifications in all equipment manuals. Read fluid and solvent manufacturer's warnings. For
complete information about your material, request Safety Data Sheets (SDSs) from distributor or
retailer.
•
Turn off all equipment and follow the Pressure Relief Procedure when equipment is not in use.
•
Check equipment daily. Repair or replace worn or damaged parts immediately with genuine
manufacturer's replacement parts only.
•
Do not alter or modify equipment. Alterations or modifications may void agency approvals and
create safety hazards.
•
Make sure all equipment is rated and approved for the environment in which you are using it.
•
Use equipment only for its intended purpose. Call your distributor for information.
•
Route fluid lines, cords, and cables away from traffic areas, sharp edges, moving parts, and hot
surfaces.
•
Do not kink or over-bend fluid lines, cords, or cables. Do not use fluid lines, cords, or cables to pull
equipment.
•
Keep children and animals away from work area.
•
Comply with all applicable safety regulations.
4
Triplex Sales
1-847-839-8442
www.triplexsales.com
WARNING
3A9286B
Advertisement
Table of Contents
