Chart Recorder (Optional)
10.2 Changing Chart
10.3 Power Supply
28
TSX Laboratory Refrigerators
Figure 13. Pressure Sensitive Chart Buttons
To change the chart paper, complete the following steps:
Paper
1. Locate the pressure sensitive buttons at the front, upper left of the
recorder panel.
2. Press and hold the change chart button (#3 in Figure 13) for one second.
The pen will move off the scale.
3. Unscrew the center nut, remove the old chart paper, and install new
chart paper. Carefully align the day and time with the reference mark on
the recorder panel (a small groove on the left side of the panel, as shown
in Figure 12).
4. Replace the center nut and hand tighten. Press the change chart button
again (#3) to resume temperature recording.
Note Be careful not to pull up on the chart recorder arm while changing
paper. Pulling on the arm may damage the recorder.
CAUTION: Do not use sharp or pointed objects to depress the chart
buttons. This may cause permanent damage to the recorder.
The recorder normally uses AC power when the system is operating. If AC
power fails, the LED indicator on the recorder flashes to alert you to a power
failure. The recorder continues sensing cabinet temperature and the chart
continues turning for approximately 24 hours with back-up power provided
by the nine-volt battery.
The LED indicator glows continuously when main power is functioning
and the battery is charged.
When the battery is low, the LED flashes to indicate that the battery needs
to be changed.
Thermo Scientific