Chart Recorder (Optional); Set Up And Operation - Thermo Scientific TSX2305SA Installation And Operation Manual

10 Chart Recorder
(Optional)
10.1 Set Up and
Operation
Thermo Scientific
Panel-mounted six inch recorders are available as a factory-installed option.
Recorder operation begins when the system is powered on.
To prepare the recorder to function properly, complete the following steps:
1. Open the recorder door to access the recorder.
2. Connect the nine volt DC battery located at the recorder's upper right
corner. This battery provides back-up power.
3. Install clean chart paper (refer to Section 10.2 below).
4. Close the recorder door.
Note The recorder may not respond until the system reaches temperatures
within the recorder's range.
Figure 12. Chart Recorder
Label Description
1 Pressure Sensitive Chart Buttons
2 Imprinting Stylus
3 Reference Mark
4 Hub-Nut and Retaining Wire
5 Chart

Chart Recorder (Optional)

TSX Laboratory Refrigerators 27