Thermo Scientific TSX2305SA Installation And Operation Manual page 18

Installation
14 TSX Laboratory Refrigerators
Table 4. Tools Required
Wood Floor
Flashlight
Tape Measure
"
1/2 (13 mm) Wrench
"
3/4 (19 mm) Wrench
Drill
"
15/64 (6 mm) Drill Bit
1. Locating the Bracket
a. Determine where you want the centerline of the refrigerator to be.
b. Place the included template on the floor lined up with the centerline
of the refrigerator and keep 6"- 12" between the wall and the back of
the unit.
c. On the floor, mark the location of Hole #1 & Hole #2.
2. Anti-Tip Bracket Installation
Wood Construction
a. Drill 15/64" (6 mm) pilot holes in locations marked in step 1.
b. Place bracket on floor aligned with holes.
c. Use supplied lag bolts to attach bracket to floor.
Concrete Construction
a. Drill 1/2" (13 mm) holes in locations marked in step 1 with
masonry bit.
b. Slide lag screw anchors into holes to be flush with floor surface.
c. Place bracket on floor aligned with holes.
d. Use supplied lag bolts to attach bracket to floor.
3. Adjusting Bolt in Refrigerator
a. Locate 1/2" bolt attached to bottom of cabinet.
b. Unscrew 1/2" bolt until there is 1/2" clearance between floor and
head of bolt as shown in the Figure 9 below.
c. Tighten lock nut against bottom of unit.
Concrete Floor
Hammer Drill
"
1/2 (13 mm) Masonry Bit
Thermo Scientific