Thermo Scientific TSX2305SA Installation And Operation Manual page 14

Installation
7.5.2 Reinstalling the Drawers
7.5.3 Changing Drawer
10 TSX Laboratory Refrigerators
Figure 2. Drawer Removal
Label
1
2
3
To reinstall the drawers, complete the following steps (refer to Figure 2):
1. Pull both the slides of the drawer towards you until the slides are fully
extended.
2. Position the drawer between the slides and with the back facing end
raised at 45 degree angle, insert the mounting clips at the front into the
slots on front of the slides.
3. Push the back of the drawer down between the slides and insert the
basket tabs into the slots at the back.
Note The drawers fit snugly between the slides. Push on the back of the
drawer from the inside to insert the drawer tabs completely into the slots.
Make sure both the drawer tabs are aligned with the slots on the slides
before pushing the drawer down between the slides.
CAUTION: Be careful when reinstalling the drawers to avoid possible
pinching.
Drawer slides have a small wire safety clip at the front pilaster which prevent the
slides from falling when the drawer is removed. To change the position of the
Position
drawer slides, complete the following steps:
1. Locate the safety clip.
Description
Tabs
Drawer slide
Slot
Thermo Scientific