Installation Procedure - Supero SC813 Series Installation Manual

1-2

Installation Procedure

Following the steps in the order given will eliminate the most common problems
associated with this install. Before beginning, you should power down the system
and remove the power cord.
Removing the Front Panel USB/COM Port Tray
1. With the power removed from the system, first remove the top chassis cover
(refer to the system manual for help).
2. A COM2 and one or two USB cables run from the tray to the motherboard.
Detach these cables from the motherboard.
3. Find the release tab at the rear left of the USB/COM port tray. Push this tab
in to unlock the tray, then push the tray out through the front of the chassis, along
with the cables you just detached from the motherboard and which are still at-
tached to the ports at the front of the tray.
Assembling the Floppy Kit
Check that all the items shown on the previous page have been included in your
floppy kit.
1. Attach the two rails to the sides of the floppy drive with the four small screws.
2. Connect the small ribbon cable included in the kit to the appropriate connector
on the floppy drive.
3. Use the large screw to attach the adapter to the back of the floppy drive so
that the connected ribbon cable lines up with the CN1 connector on the adapter.
Attach the other end of the small ribbon cable to the CN1 connector on the floppy
drive adapter.
1-3
Adding a Floppy Drive