Rail Installation - Supero SC813 Series Installation Manual

C. Rail Installation
Rail Packaging includes:
*One pair of inner slides to be installed on the chassis,
*One pair of outer slides to be installed in the rack,
*Two pairs of short brackets to be used on the front side of the outer slides
(Note: One pair of short brackets include screw threads, and the other pair
do not. Use the only pair that will fit into your rack.),
*One pair of long brackets to be used on the rear side of the outer slides
C-1 Installing Inner Slides
Procedures
1. Locate the right inner slide, (-the slide that will be used on the right side
of chassis when facing the front panel of the chassis).
2. Align the four(4) square holes on the right inner slide against the hooks
on the right side of the chassis as show below on the left.
3. Securely attach the slide to the chassis with two
and repeat the steps 1-3 to install the left inner slide to the left side of the
chassis.
Four(4) hooks on the right
side of the chassis
two M4 screws
C-2 Installing Outer Slides
1. Measure the distance from the front rail of the rack to the rear rail of the
rack.
2. Attach a short bracket to the rear side of the right outer slide, and a long
bracket to the front side of the right outer slide as shown above on the
right.
3. Adjust the short and long brackets to the proper distance so that the
chassis can snugly fit into the rack.
4. Secure the slides to the cabinet with screws. Repeat steps 1-4 for the
left outer slide.
Four 4 square holes on
the right inner slide
2-3
Chapter 2: Installation Procedures
Slide the long bracket into
the short bracket
Adjust the distance
between the brackets
flat head screws
M4