D-1. Rack Installation For The Traditional 1U Design - Supero SC812 Series Installation Manual

Chapter 2: Installation Procedures
D-1 Rack Installation for the Traditional 1U Design
After you have installed the inner rails on the chassis, you are ready to
install the outer rails of rail assemblies to the rack.
(* The rails are designed to fit in the racks with the depth of 28" to
33".)
Procedures
1. In the package, locate a pair of front (-short) and rear (-long) brackets.
Please note that the brackets are marked with Up/Front Arrows (-front) and
Up/Rear arrows (-rear).
2. Secure the front (-short) bracket (marked with the Up/Front arrows) to
the outer rail with two Type G screws.
3. Attach the rear (-long) bracket to the other end of the outer rail and
secure the rear (long) bracket to the outer rail with a Type G screw as
shown below.
4. Measure the depth of your rack and adjust the length of the rails accord-
ingly.
5. Repeat the same steps install the other outer rail on the chassis.
6. Secure both outer rail assemblies to the rack with Type H screws and
Type I washers.
6
H
I
4
3
G
2
G
2-7