B-2. Removing And Installing The Hard Drive Disks - Supero SC812 Series Installation Manual

B-2. Removing/Installing the Hard Drive Disks
(*Note: For the SC812L Chassis.)
B-2 Procedures (Removing the HDD Drive from the SC812L):
1. Remove the screw as shown below to detach the HDD drive tray from
the chassis.
2. Push the HDD drive tray backwards until the drive tray is released
from the two fastening tabs located in front of the chassis.
3. Once the HDD drive tray is detached from the chassis, remove the two
screws on each side of the drive tray to separate the HDD from the drive
tray as shown below.
2. Push the drive tray back-
wards to release it from the
chassis.
(*Note: Reverse the steps listed above to install the HDD into the
chassis.)
Chapter 2: Installation Procedures
3. Remove the screws
to loosen the HDD from
the drive tray.
2-3
1. Remove the screw.