Table of Contents
Advertisement
www.ti.com
4 BQ79600EVM Quick Start Guide
This section includes hardware setup instructions, connection procedures, and software and GUI instructions.
4.1 Required Devices for Using the Example Code *Not Available Yet*
The system example code is implemented using the LAUNCHXL2-TMS57012 LaunchPad
(TMS570LS1224 MCU), the BQ79600EVM, and the BQ79616EVM via Code Composer Studio.
The part numbers of the evaluation modules are LAUNCHXL2-TMS57012, BQ79600EVM-030,
BQ79616EVM-021. These boards are available from the TI eStore (https://estore.ti.com/) or from your local
TI sales representative. For more details and information related to the LaunchPad
module user's guide.
4.2 Power Connections
The BQ79600EVM can be powered up either using a 5-V supply or a 12-V supply. To use the 5-V option, make
sure that jumpers J1 and J3 are connected in the "5V" position as labeled in the board, and then connect the
positive terminal of the 5-V supply to the "5V" testpoint provided on the board, and the power supply negative
terminal to the "GND" testpoint provided on the board, or any "GND" standoff provided. To use the 12-V option,
verify that jumpers J1 and J3 are connected in the "12V" position as labeled in the board, and then connect the
positive terminal of the 12-V supply to the "12V" testpoint provided on the board, and the power supply negative
terminal to the "GND" testpoint provided on the board, or any "GND" standoff provided.
4.3 Connecting the BQ79600EVM to TMS570 LaunchPad
The EVMs are connected using the female connectors J7 and J9 on the bottom side of the BQ79600EVM and
the male connectors J2, J3, J4, and J5 on the top side of the LAUNCHXL2-TMS57012 LaunchPad
the J7 20-pin female connector on the bottom side of the BQ79600EVM to the J2 and J3 10-pin male connectors
on top side of the LAUNCHXL2-TMS57012 LaunchPad
of the BQ79600EVM to the J4 and J5 10-pin male connectors on the top side of the LAUNCHXL2-TMS57012
™
LaunchPad
, as shown in the following figure. By default, the TMS570 LaunchPad is powered by the USB port
on the host computer. Remove JP1 from the LaunchPad for correct operation.
The microcontroller is used to supply VIO voltage to the device. The user can select either the 3.3-V or 5-V
option. To use 3.3 V, make sure that JP2 on the microcontroller LaunchPad is connected and set jumper J6 in
SLUUC57B – OCTOBER 2019 – REVISED AUGUST 2023
Submit Document Feedback
Figure 4-1. Basic EVM Setup
™
, and J9 20-pin female connector on the bottom side
Copyright © 2023 Texas Instruments Incorporated
BQ79600EVM Quick Start Guide
™
board
™
modules, see the specific
™
. Connect
BQ79600-Q1 Evaluation Module
11
Advertisement
Table of Contents
