I-3 Network IP Configuration
After the network connection is built, the next step you should do is setup VigorAP 1000C with
proper network parameters, so it can work properly in your network environment.
Before you can connect to the access point and start configuration procedures, your computer must
be able to get an IP address in the same subnet as this AP. If it's not connected to the same DHCP
Server with the AP or you're unsure, please follow the following instructions to configure your
computer to use the static IP address in the same subnet as default IP address of this AP.
For the default IP address of this AP is set "192.168.1.2", we recommend you to use "192.168.1.X
(except 2)" in the field of IP address on this section for your computer.
If the operating system of your computer is...
Windows 10
- please go to section I-3-1
I-3-1 Windows 10 IP Address Setup
Click the Start button (it should be located at lower-left corner of your computer), then click the
Settings icon.
Double-click Network & Internet.
8