Dhcp Server - Seenergy SVR- 632 User Manual

86 SVR-­‐632 U ser's M anual
2. Enter the IP address, subnet mask, default gateway address and
DNS server address for the recorder
* The recorder can detect the presence of a DHCP server upon startup.
It sets itself to use static IP address if there is no DHCP server
currently presented in the network. Its DHCP server function is also
turned on at the same time to assign IP addresses to cameras that are
later connected to the network or you can manually turn off the DHCP
server function from "System Configurations">>"Network
Setup">>"DHCP Server" if you wish to use a separate DHCP server.

DHCP Server

The built-in DHCP Server function is NOT always configurable and is
greatly dependant to the connection type that is set to use in "Device
Network Setting":
1. If the connection type is "Auto Mode", the DHCP server function is
NOT configurable. It will be ON if the NVR doesn't obtain an IP from a
DHCP server in the local network and uses its own default static IP
192.168.101.50
2. If the connection type is "Auto Mode", the DHCP server function is
NOT configurable. It will be OFF if the NVR obtains an IP from a DHCP
server in the local network.
3. If the connection type is "DHCP Client", the DHCP server function is
NOT configurable. It will be OFF if the NVR obtains an IP from a DHCP
server in the local network.
4. If the connection type is "DHCP Client", the DHCP server function is
NOT configurable. It will be ON if the NVR doesn't obtain an IP from a
DHCP server in the local network and uses its own default static IP
192.168.101.50
5. If the connection type if "Static IP", the DHCP server function is
configurable and can be turn on/off manually.