Seenergy SVR- 632 User Manual page 216

216 SVR-­‐632 U ser's M anual
•Add system events if you will
•Where the warnings will be sent to and how they will be sent.
Use the checkbox to enable event trigger on the desired channels.
*Once motion detection is enabled in this page, please configure the
motion area and enable motion detection in the corresponding
channels (cameras) from camera's own web UI. The NVR only detects
the first motion area set in the camera. The NVR recognizes the first
motion area by its ID number set in the camera.
* Grayed out checkboxes represent the function that is either not
available on the camera, or the event notification method used in the
camera is not supported by the NVR.
* Enabling "Custom Event" allows events from the CMS software to
trigger the NVR to start recording.
Define which system events should trigger the recorder to send out
notifications if you will.