*Once motion detection is enabled in this page, please configure the
motion area and enable motion detection in the corresponding
channels (cameras) from camera's own web UI. The NVR only detects
the first motion area set in the camera. The NVR recognizes the first
motion area by its ID number set in the camera.
* Enabling the "custom event" option allows the NVR to receive events from the CMS
software and start recording; events such as the intelligent video detection in the
CMS.
Define which system events should trigger the recorder to send out
notifications.
Define how the notifications will be sent and where they will be sent.
• Event trigger may not work for cameras that are placed outside
of your local network or on the Internet until the "UPnP Port
Forwarding" is enabled in both the NVR and the router.
SVR-‐632
U ser's
M anual
133