156
SVR-‐632
U ser's
M anual
The UPS information should be obtained and displayed at the bottom
of the page after the settings are applied:
To enable network UPS support (NVR acting as UPS
slave):
1. Go to "NVR Setup" >> "System Options" >> "UPS Configurations",
and check "Enable UPS Support" option.
2. Enter the IP address of the NVR running as UPS server. (The
NVR with USB UPS physically attached to)
* Please make sure both NVRs (UPS server and slave) are on the same
local network to ensure the communication between the two.
* Please make sure both NVRs are plugged into the outlets that
connect to the UPS.